1.25 LC MU Fiber Optic Cleaning Pen
The Optical Connector Cleaner (LC/MU) is used to clean the ferrule end face of 1.25mm connectors in adapters (intended for cleaning adapters in installed patch panels). Thanks to the appropriate guide cap, the cleaner can also be used for cleaning the ferrule end face of patch cords and pigtails.
The connector end face is cleaned by making contact with the cleaner tip. This action is followed by rotating the cleaner tip around its axis, then the cleaning thread is fed in. The cleaning thread length is enough to perform about 800 cleaning operations with one cleaner. The device features a retractable mechanism to facilitate operation in high density fiber optic distribution frames.
Features & Specifications
1.25 LC MU Fiber Optic Cleaning Pen
Single click activation
Easy to use and efficient
Lightweight and safe
Compact body
Anti-static design prevents secondary contamination
Optimized for in-situ/behind the panel cleaning
Plastic base minimizes concern for fiber tip damage
Standards Compliance IEC-61300-3-35; IEC-TSB-XYZ
Tx/Rx cleaning
Why is Cleaning Important?
A clean connector is critical to the dependability of any optical network architecture. When mated, connector end faces have even little amounts of dirt (skin oils, dust, lotions, water residue, etc.) they will suffer not only from power degradation but also an increased probability of permanent damage. Good cleaning techniques, proper training and the use of dependable cleaning tools will help prevent signal degradation, residue cross-contamination, and will reduce lasting effects of contamination.
